Fusion 360 For Hobbyists and Woodworkers
Below are the top discussions from Reddit that mention this online Udemy course.
Learn by doing
Reddemy may receive an affiliate commission if you enroll in a paid course after using these buttons to visit Udemy. Thank you for using these buttons to support Reddemy.
Taught by
Michael Moyer
Reddit Posts and Comments
0 posts • 2 mentions • top 2 shown below
3 points • nicatbzade58
I have found for you a course, it is 21 hours long and costs 13$ (5 hours left for sale, but don't worry, they are almost always in sale): https://www.udemy.com/course/beginning-fusion-360/
Another one with 15 hours: https://www.udemy.com/course/fusion-360-beginners-course/
Another one with 9 hours: https://www.udemy.com/course/fusion360/
1 points • moose408
I went through multiple courses trying to learn Fusion360. Lynda.com had a couple very good ones (I believe they are free via LinkedIn). I also tried multiple free ones on Autodesk's web site, and YouTube, but I still struggled with every design. Then I came across this one on Udemy.
Fusion 360 For Hobbyists and Woodworkers https://www.udemy.com/course/fusion360/ and suddenly everything clicked for me. His use of parameters for everything really resonated with me.
I believe a lot of it is repetition and watching multiple guides until you have that ah-ha moment.
(btw, tip on Udemy. The lowest price is always the first time you go look at a course, if you leave and come back the price will go up).